Filter
Top Products
English - 29
3. INSTALLATION
Laying out the boundary wire
Run the boundary wire around the working area, but
wait before connecting the wire to the charging
station.
Tip! Use the supplied measurement gauge as a
guide when you lay out the boundary wire. This helps
you to easily set the correct distance between the
boundary wire and the boundary/obstacle.
If you intend to staple down the boundary wire:
• Tip! Mow the lawn where the wire is to be laid
using a normal lawn mower or a trimmer. It will
then be easier to lay the wire close to the ground
and the risk of the mower cutting the wire off is
reduced.
• Make sure to lay the boundary wire tight to the
ground and secure the staples close together with
approximately 30" between each staple. The wire
must generally lie close to the ground, so as not to
be cut off before the grass roots have grown over
it.
• Use a hammer to knock down the staples in the
ground. Exercise care when knocking in the
staples and make sure the wire is not under
strain. Avoid forming the wire in sharp bends.
If you intend to bury the boundary wire:
• Make sure to place the boundary wire at least
0.5" and a maximum of 8" into the ground.
IMPORTANT INFORMATION
Extra wire must not be placed in coils outside
the boundary wire. This can disrupt
Automower™.
3012-221
3012-281
3012-745