Filter
Top Products
42 – English
LUBRICATION
Checking the engine’s oil level
Check the oil level in the engine when the Rider
stands horizontal and the engine is switched off.
Fold open the engine cover.
Release the dip stick and pull out. Wipe off the oil
and insert again without screwing it in.
The dip stick must be fully screwed down.
Pull out the dip stick. Check the oil level.
The following engine oils are recommended:
• API Service Classification: SF, SG, SH or SJ
Choose the viscosity according to the temperatures
in the picture:
Do not mix different types of oil.
Remember that using multi grade oils (5W-20,
10W-30, and 10W-40) will increase oil
consumption. Check oil level more frequently when
using them.
The oil level should be between the markings on
the dip stick. If the level approaches the ADD mark,
top up with oil to the FULL mark.
The oil is filled in the same hole as for the dip stick.
Fill the oil slowly. Tighten the dipstick correctly
before starting the engine. Start and run the engine
at idling speed for approx. 30 seconds. Turn off the
engine. Wait 30 seconds and check oil level. If
necessary fill so that the oil comes up to the “FULL”
mark on the dip stick.