Filter
Top Products
30 – English
MAINTENANCE
Ignition system
The engine is equipped with an electronic ignition system. Only the spark plugs require maintenance.
For recommended spark plug, see chapter ”Technical data”.
IMPORTANT INFORMATION
Fitting the wrong spark plug type can damage the engine.
1. Remove the ignition cable shoe and clean around the spark plug.
2. Remove the spark plug with a 3/4" (19 mm) spark plug socket wrench.
3. Check the spark plug. Replace the spark plug if the electrodes are burned or if the insulation is cracked
or damaged. Clean the spark plug with a steel brush if it is to be reused.
4. Measure the electrode gap with a gapping tool. The gap should be 0.75 mm/0.030". Adjust as necessary
by bending the side electrode.
5. Reinsert the spark plug, turning by hand to avoid damaging the threads.
6. After the spark plug is seated, tighten it using a spark plug wrench so that the washer is compressed. A
used spark plug should be turned 1/8 of a turn from the seated position. A new spark plug should be
turned 1/4 a turn from the seated position.
7. Replace the ignition cable shoe.
IMPORTANT INFORMATION
Inadequately tightened spark plugs can cause overheating and damage the engine. Tightening
the spark plug too much can damage the threads in the cylinder head.