Husqvarna 15V2 AWD Lawn Mower User Manual


 
2 – English
INTRODUCTION
Dear customer
Thank you for choosing a Husqvarna Rider. Husqvarna Riders are built to a unique design with a
frontmounted cutting unit and a patented rear-wheel steering system. Riders are designed for maximum
efficiency even in small or confined areas. Collected controls and a hydrostatic transmission controlled by
pedals also contribute to the machine’s performance.
We hope you will find this operator’s manual very useful. By following its instructions (on operation, service,
maintenance, etc.) you will significantly extend the life of the machine and even its second-hand value.
When you sell your Rider, make sure you pass on the operator’s manual to the new owner.
Travel and transport on public roads
Check the relevant road traffic regulations before driving the machine on a public road. If transporting the
machine on another vehicle always use approved securing devices and make sure that the machine is
securely held.
Towing
Your machine is equipped with a hydrostatic transmission and, if necessary, you should only tow the machine
over short distances and at a low speed, otherwise there is a risk of damaging the transmission.
Intended use
This machine has been designed to mow grass on lawns and other open and level ground surfaces without
obstacles such as stones, tree stubs, etc., even when the machine is equipped with special accessories
provided by the manufacturer, for which the operating instructions are provided in conjunction with delivery.
Use in any other way is considered as contrary to the intended use. Compliance with and strict adherence to
the conditions of operation, service and repair as specified by the manufacturer also constitute essential
elements of the intended use.
This machine should be operated, serviced and repaired only by persons who are familiar with its particular
characteristics and who are acquainted with the relevant safety procedures.
Accident prevention regulations, all other generally recognised regulations on safety and occupational medi-
cine, and all road traffic regulations must be observed at all times.
Any arbitrary modifications carried out to this machine may relieve the manufacturer of liability for any
resulting damage or injury.