Filter
Top Products
34– English
2
6008-026H
6017-155
Adjusting the parallelism of the Cutting
deck on Rider 11 C, Rider 13 C, Rider 15 C
1. Check that the tyres’ air pressure is 60 kPa
(0.6 kp/cm
2
/8.5 PSI).
2. Remove the front cover and the right-hand
wing cover.
3. Loosen the parallelism stay’s nuts.
4. Screw out (extend) the stay to raise the rear
edge of the cover. Screw in (shorten) the stay
to lower the rear edge of the cover.
5. Tighten the nuts after adjustment.
6. The parallelism should be checked again after
the adjustment has been made.
7. Fit the right-hand wing cover and the front
cover.
MAINTENANCE
Adjustment of the cutting unit’s
parallelism for the Rider 11
1. Check the tyre air pressure. It should be 60 kPa
(0,6 kp/cm
2
).
2. Dismantle the front hood and right-hand fender
as described on page 22-23.
3. Vertical adjustment of the cutting unit is made
with the adjusting nuts on the back edge of the
lift-strut.
4. Raise the cutting unit at the front edge by
shortening the lift-strut.
Lower the cutting unit at the front edge by
lengthening the lift-strut.
5. Tighten the nuts against each other after the
adjustment.
6. On completion of the adjustment the unit’s
parallelism should be re-checked.
7. Fit the right-hand fender and the front hood.
6021-023
Removing the mulching plug
In order to change a combi unit from the mulching
function to a cutting unit with rear ejection, remove
the mulching plug located under the cutting unit
using the knob.
1. Put the cuttin deck in the service position, see
”Placing in the service position”.
2. Loosen the knob holding the mulching plug and
remove the plug.
3. Return the unit to the normal position.
To fit the mulching plug, follow the instructions in
the reverse order.