Filter
Top Products
English – 21
MAX 15°
STOP START
6007-013
6007-014H
6007-015
8009-574
DRIVING
Release lever Rider 13 C and Rider 15 C
In order to move the machine when the engine is
switched off the release lever must be pressed
down and forwards.
2. Rider 11 and Rider 11 C: Pull back the throttle
control and put the gear lever into neutral ”N”
without pressing the reverse lock button. Turn
the ignition key to the ”STOP” position.
Rider 13 C and Rider 15 C: Pull back the
throttle lever and turn the ignition key to the
”STOP” position.
3. When the rider mower is stationary, hold down
the parking brake and push in the lock button.
WARNING!
Never drive the machine on
ground with a slope of more than
15°. Mow slopes upwards and
downwards, never across. Avoid
sudden changes in direction.
Hill start, manual gearbox
1. Press down the parking brake.
2. Push the throttle control to full throttle position.
3. Push down the clutch and engage first gear.
4. Carefully release the clutch.
5. When the engine starts to pull, release the
parking brake.
Stopping the engine
Preferably allow the engine to idle for a minute to
obtain normal working temperature before stopping
it if it has been working hard.
1. Lift up the cutting unit by pulling the lever back to
the end position.