Filter
Top Products
English – 41
TECHNICAL DATA
1153137-49 Rev.1 2009-12-29
Recommended cutting equipment for Canada
Following is a list of recommended cutting equipment for the Husqvarna chain saw model 455 Rancher, 455e Rancher
and 460 Rancher. The combinations of powerhead, bar and chain meet all requirements outlined in the CSA Z62.1-03
Chainsaws and Z62.3-04 Chainsaw Kickback standards.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose r
adius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy.
A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent
or less kickbac
k energy than the sprocket-nose bar.
We recommend that you as replacement use the listed bars and chains or ”Type C Low-Kickback Saw Chains” which
are available at your dealer.
Bar and chain combinations
Note: For the saw chains above (if available) you are free to choose between 0,050" or 0,058" gauge drive links for the
corresponding bar, see the table below
Saw chain filing and file gauges
Bar Chain
Length, inch Pitch, inch Gauge, inch Max. nose radius Type
Drive link
count
15 3/8
0,050
11T
Husqvarna H80,
Husqvarna H46,
Husqvarna H47
56
16 3/8 11T 60
18 3/8 11T 68
20 3/8 11T 72
24 3/8 11T 84
Gauge, in. Saw chain designation
0,050 H80 H46 H47
0,058 H81 H42 H48