Filter
Top Products
25
PROBLEM OR CONCERN POSSIBLE CAUSE SOLUTION
Kink in the Garden Hose or Hose
is wrapped on a storage wheel
Unwrap the Garden Hose and lay it out flat to
ensure that there are no kinks in the Hose.
Detergent Suction Assembly (the
part which the High Pressure
Hose connects to) is defective
Remove the Gun and Hose assembly from the front of
the unit. Aim water stream away from electric sour-
ce. Turn the faucet on. Water should start to come
out of the front of the unit. If no water comes out, the
Detergent Suction Assembly will have to be replaced.
Contact us at customerservice@huskypower
washer.com or order a replacement directly onli-
ne at www.huskypowerwasher.com.
Gun/Hose Assembly is defec-
tive
Attach the Gun/Hose to the front of the unit with no
wand attached to the Gun. Squeeze the trigger of
the gun to ensure that water comes out of the front
of the Gun at a rate equal to the Garden Hose. If no
water comes out of the Gun it will have to be repla-
ced. Contact us at
customerservice@huskypo
werwasher.com or order a replacement directly
online at www.huskypowerwasher.com.
Trigger will not move Gun Safety Lock is engaged Release Safety Lock as instructed in Manual.
Unit will not start
Note: Unit will only start when
trigger is depressed.
Unit stops while operating
Unit is not turned on Press ON/OFF Switch into ON position.
Loose or disconnected Plug Reconnect Plug.
Defective GFCI Plug Perform GFCI reset procedure as instructed in
Section 2.0. If the Plug does not reset it will
need to be replaced. Contact us at custome
rservice@huskypowerwasher.com or
order a replacement directly online at www.
huskypowerwasher.com.
Extension Cord length or gauge
incorrect
Use proper Extension Cord as instructed in section
2.0.
Gun trigger not operating pro-
perly
Contact us at customerservice@huskypow
erwasher.com or order a replacement directly
online at www.huskypowerwasher.com.
Defective Gun Remove the Gun and Hose assembly from the front
of the unit. Aim water stream away from electric
source and switch the unit into the ON position.
If the unit starts and water comes out of the front,
the Gun may need to be replaced.
Contact us at
customerservice@huskypowerwasher.
com or order a replacement directly online at
www.huskypowerwasher.com.
Tripped Pressure washer Ther-
mal Switch
Allow to cool and restart unit.
Defective ON/OFF Switch
Contact us at customerservice@huskypow
erwasher.com or order a replacement directly
online at www.huskypowerwasher.com.
Unit will not stop when trig-
ger is released
Screen filter is clogged Clean the Screen filter as instructed in section
5.4.
Garden Hose is kinked or
leaking water
Make sure the Garden Hose is laid out flat and
there are no kinks in it. The hose should not be
wrapped on a storage wheel. Make sure the
faucet is open all the way and there is a full
volume of water reaching the unit.