Filter
Top Products
6
42858-01 • 09/10/09 • Hunter Fan Company
3 • Assembling Pipe / Ball Assembly
6
Figure 3b
Figure 3a
2 1/2”
Pipe
4 1/2” Pipe / Ball
Assembly
Positioning
Screw
Pin
Your Hunter fan comes with an optional downrod extension pipe. If
you would like to use the enclosed optional downrod, complete the
steps below.
If you are going to install the fan using the standard downrod, go to
“Step 4 - Assembling the Fan.”
Removing Ball Assembly
For the following steps refer to Figures 3b and 3c.
3-1. Locate the 4 1/2" pipe/ball assembly.
3-2. Remove the positioning screw from the top of the ball.
Note: e ball will become loose and should slide down the pipe.
3-3. Remove the ball from the pipe.
3-4. Remove the pin from the pipe.
3-5. Carefully loosen and remove the ground screw/leadwire assembly
from the pipe.
3-6. Locate the 2 1/2" pipe.
3-7. Insert and tighten the ground screw/leadwire assembly into the
small screw hole on one end of the 2 1/2" pipe.
3-8. Insert the pin into the two holes in the 2 1/2" pipe so that the pin
is placed evenly in the hole.
3-9. Insert the threaded end of the pipe into the at side of the ball.
3-10. Align the cutouts in the ball with the pin and the ground screw
assembly.
3-11. Slide the ball up the pipe until it hits the pin.
3-12. Insert and tighten the positioning screw into the ball so that the
head of the screw is placed on the end of the pipe.
Note: Make sure that the ball is positioned so that it is level or
straight.
Figure 3c
Ball
Ground
Screw
Leadwire
Assembly
CAUTION
• Make sure that the leadwire asembly is
pointing straight up and away from the pipe
• To avoid possible electrical shock, the
ground screw must be tightened securely.
• Failure to complete the steps above
properly could result in the fan falling.
• Do not overtighten the postioning screw
as it may cause the ball to seat improperly,
resulting in fan wobble andthe fan haing
crokedly