Filter
Top Products
27
One Touch Manual Start and Advance
You can also activate all stations to water without using the dial.
1. Hold down the button for 2 seconds.
2. This feature automatically defaults to program A. You can select
program B, C or D by pressing the program.
3. The station number will be flashing. Press the or button to
scroll through the stations and use the and buttons to adjust
the station run times. (If no buttons are pressed during step 2 or 3,
the controller will automatically begin program A.)
4. Press the button to scroll to the station you wish to begin with.
After a 2 second pause, the program will begin.
This feature is great for a quick cycle when extra watering is needed or
if you would like to scroll through the stations to inspect your system.
SEASONAL ADJUSTMENT
Seasonal Adjust is used to make global run time changes without
reprogramming the entire controller. This feature is perfect for making
small changes that are necessary as the weather changes without
reprogramming the entire controller. For instance, hotter times of the
year may require a bit more water. Seasonal adjust can be increased so
that the stations will run longer than the programmed time. Conversely,
as Fall approaches, the seasonal adjust can be reduced to allow for
short watering durations.
To use the seasonal adjust, simply press the up or down seasonal
adjust buttons to set the percentage desired. Each bar on the graph can
be adjusted from 10% to 150% of original program. The season adjust
can be changed at any time regardless of the programming dial
position. To view the new adjusted run time, simply turn the rotary dial
to the SET RUN TIMES position, the displayed run time will be updated
accordingly as the seasonal adjustment is made.
NOTE: The controller should always be initially
programmed in the 100% position.
5. Use the button to move to the next station.
6. Repeat steps 3 and 4 to customize each station if desired.
7. Press the button until desired starting station is displayed.
8. Return the dial to RUN (custom program will water the entire
program beginning with the station number last left in the display,
then controller will return to automatic mode with no change in the
previously set program).
NOTE: The station that is on the display when you
turn the dial to RUN, will be the first station to run.
The controller will then proceed to water in
sequential order only. It will not water previous
stations. Example: If you turn the dial to RUN with
the display reading station 3, the controller will
water Stations 3 through 9 in the program, but not
return to Stations 1 and 2.