Filter
Top Products
13
Common Wire
Master Valve
Master
Valve
Wire
Power Module
CONNECTING A MASTER VALVE .........................................................................................
NOTE: Complete this section only if you have a
master valve installed. A master valve is a
normally closed valve installed at the supply point
of the main line that opens only when the auto-
matic system is activated.
1. At the Master Valve, attach the common wire to either solenoid wire
of the valve. Attach a separate control wire to the remaining
solenoid wire.
2. Route the wires into the controller via the field wire conduit.
3. Connect either wire from Master Valve to the P/MV terminal.
Connect remaining wire to the C (Common) terminal.