Filter
Top Products
4
Remove all packaging material.
Remove separate accessory box.
Remove the generator from carton.
Check all contents. If any parts are missing or damaged, locate an
authorized dealer at 1-855-GEN-INFO.
1-Owner’s manual
1-Bottle of Oil SAE 30
3-Product Registration Cards (English, Spanish, French)
1-Oil Funnel
4-Curved Head Bolts (A)
4-Acorn Nuts (B)
2-Small Washers (C)
2-Rubber Feet (D)
2-Foot Brackets (E)
2-Long Hex Head Bolts (F)
8-Short Hex Head Bolts (G)
10-Nuts (H)
1-Axle (J)
1-Axle Bracket (K)
2-Wheels (L)
2-Large Washers (M)
2-Hair Pins (N)
The generator requires some assembly prior to using it. If
problems arise when assembling the generator, please call the
Generator Helpline at 1-855-GEN-INFO.
The wheels are designed to greatly improve the portability of the
generator. You will need the following tools to properly install the
accessory kit:
Ratchet and a 10mm socket
10mm box wrench
Refer to the instructions below and figures 1A, 1B, and 1C to
install the handles, feet, and wheels. Note: the handle components
are already pre-assembled from the factory.
1. Install the handle assembly to the frame by using bolts (A) and
nuts (B).
2. Repeat step one for opposite handle.
3. Place washer (C) inside rubber foot (D). Secure parts to
bracket (E) with bolt (F) and nut (H).
4. Install foot assembly to the frame using the short bolts (G)
and nuts (H).
5. Repeat steps 3 & 4 for other foot.
6. Use four short bolts (G) and four nuts (H) to secure the axle
(J) & bracket (K) to the frame.
7. Slide wheel (L) and washer (M) onto axle (J). Secure parts
with pin (N).
8. Repeat steps 6 & 7 for the opposite wheel.
Figure 1A Handle Assembly
Figure 1B Foot Assembly
General Information