Filter
Top Products
150005MA010302A
1.36
1.36
MAINTENANCE
CUTTERDECK Continued.
Cutterdeck Removal:
- Refer to the ‘Cutterdeck Lever Setting’procedure and move the height of cut
lever to the deck levelling position.
- Remove the R-clips and washers from the rear suspension brackets.
- Remove the R-clips and washers from the rear lift links.
- Disconnect the extension spring from the chassis.
- Remove the R-clip from the hanger rod. Push the hanger rod through and
then withdraw from between the hanger brackets. Allow the front suspen-
sion bracket to hinge forward and lay on the ground.
- Remove the primary drive belt from the elective clutch output pulley.
- Pull the cutterdeck assembly away from beneath the tractor.
Cutterdeck Attachment:
- Follow the cutterdeck removal procedure in reverse order to install the cutterdeck.
- Ensure that the primary drive belt is correctly routed and located.
- Follow the ‘Cutterdeck Level Setting’ procedure to ensure correct set-up and operation.