Filter
Top Products
150005MA010302A
1.20
1.20
OPERATING THE TRACTOR
SEAT POSITION
The seat can be adjusted forward or backwards. Raise the seat (1),
loosen the adjuster knobs (2), adjust the seat to the desired position and
re-tighten the adjuster knobs. Lower the seat.
IMPORTANT - Ensure that the adjuster knobs are fully tightened
before operation.
1. Seat
2. Adjuster Knobs
HEADLIGHTS
The lights are an integral function of the ignition switch. Turn the ignition key to the symbol to switch
them on.
CUTTERBLADE CONTROL
The cutterdeck drive switch engages and disengages drive to the cutterblades.
- Engage Drive: Pull the cutterdeck drive switch out.
- Disengage Drive - Push the cutterdeck drive switch in.
HEIGHT OF CUT SETTING
The height of cut lever is used to raise and lower the cutterdeck to the
desired height of cut.
Move the height of cut lever inwards to disengage it from the height of
cut notches, then push forwards to lower or pull backwards to raise the
height of cut. Release the lever into the required position and ensure
that it locks securely into the appropriate notch. There are six height of
cut positions. These are indicated by the numbered notches, 1 to 6.
IMPORTANT: Always select the height of cut to suit operating con-
ditions. Prevent engine overloading and blockages by avoiding low
cuts in long grass conditions. Be prepared to make two cuts when the
grass is long.
1
2
2