Filter
Top Products
150005MA010302A
1.27
1.27
OPERATING THE TRACTOR
ATTACHING/DETACHING THE SWEEPER COLLECTOR continued.
- Whilst the sweeper collector is in this position fit the drive belt. Fitment of
the belt will be easier if the sweeper collector is pushed forwards so that
the upper linkage pins engage the recesses immediately below the linkage
hooks.
- Remove the tool tray which is situated under the seat. Place the drive belt
over the sweeper clutch and engage into the pulley.
- Fit the drive belt over the sweeper collector input pulley as shown. Ensure
that the tensioner pulley is correctly positioned. (Refer fig. 2)
- Using the lift lever raise the sweeper collector into the transport position
and engage the latch locking mechanism. (Refer fig. 3)
- Close the rear guard flap.
- Replace the tool tray and lower the seat.
Before operation, the sweeper collector must be securely latched to the pick-up points on the rear of the
tractor by engaging the latch locking mechanism.
To disengage the latch, rotate it rearwards away from the pick-up pins on the tractor lift linkage. The
attached spring will hold the latch open.
To engage the latch, rotate it towards the pick-up pins on the tractor lift linkages. The attached spring will
hold the latch closed.
Detaching the sweeper collector:
- To detach the sweeper collector follow the steps in reverse order.
Fig.3
Fig.2