Filter
Top Products
Page 7SKU 97005 For technical questions, please call 1-800-444-3353.
Maintain labels and nameplates on 5.
the equipment. These carry impor-
tant information. If unreadable or
missing, contact Harbor Freight Tools
for a replacement.
Have the equipment serviced by a 6.
qualied repair person using only
identical replacement parts. This will
ensure that the safety of the equip-
ment is maintained. Do not attempt
any service or maintenance proce-
dures not explained in this manual
or any procedures that you are un-
certain about your ability to perform
safely or correctly.
Store equipment out of the reach of 7.
children.
Follow scheduled engine and equip-8.
ment maintenance.
Refueling:
Do not smoke, or allow sparks, 1.
ames, or other sources of ignition
around the equipment, especially
when refuelling.
Do not rell the fuel tank while the 2.
engine is running or hot.
Do not ll fuel tank to the top. Leave 3.
a little room for the fuel to expand as
needed.
Refuel in a well-ventilated area only.4.
SAVE THESE
INSTRUCTIONS.
BASIC SPECIFICATIONS
Fuel
Type 89+ octane unleaded gasoline
Capacity 1.7 Gallons
Engine
Oil
Type
SAE 25W (above 32° F)
SAE 15W-40 (at 32° F or below)
Capacity 37.2 Ounces (1.1L)
Pump Oil
Type
SAE 25W (above 32° F)
SAE 15W-40 (at 32° F or below)
Capacity 15.2 Ounces (0.45L)
Note: Additional specications found in the
TECHNICAL ENGINE SPECIFICATIONS
chart in this manual.
The emission control system for this
engine is warranted for standards set by
the U.S. Environmental Protection Agency
and by the California Air Resources Board
(also known as CARB-Phase II). For
warranty information, refer to the last
pages of this manual.
At high altitudes, the engine’s
carburetor, governor, and any other parts
that control the fuel-air ratio will need to be
adjusted by a qualied mechanic to allow
efcient high-altitude use and to prevent
damage to the engine and any other
devices used with this product.
REV 09b