Filter
Top Products
Page 16SKU 97005 For technical questions, please call 1-800-444-3353.
FIGURE K
DRAIN PLUG (14)
2. Remove the Drain Plug (14) and, if
possible, tilt the Crankcase slightly to
help drain the oil out. Recycle used
oil.
Replace the Drain Plug (14) and 3.
tighten it.
Rell the oil to the proper level follow-4.
ing the instructions under the “Start-
ing the Engine” section.
Air Filter Element Maintenance
FIGURE L
WING NUT (47)
AIR CLEANER COVER (51)
1. The Air Cleaner Cover (51) is held in
place by a Wing Nut (47). Remove it.
(See Figure L.)
Remove a second Wing Nut (47) and 2.
its Washer (48). Then remove the Air
Filter Element (49).
For lter elements: 3.
To prevent injury from dust and
debris, wear ANSI-approved safety
goggles, NIOSH-approved dust
mask/respirator, and heavy-duty work
gloves. In a well-ventilated area
away from bystanders, stand down
wind, and use pressurized air to blow
dust out of the Air Filter Element
(49). If this does not get the Filter
reasonably clean, replace it.
Install the new lter or the cleaned 4.
lter. Secure the Air Cleaner Cover
before use.
Spark Plug Maintenance
Disconnect spark plug wire from 1.
end of plug. Clean out debris from
around spark plug.
SPARK PLUG (60)
SPARK PLUG WIRE
FIGURE N
2. Using a spark plug wrench, remove
the spark plug. (See Figure N.)
Inspect the spark plug: 3.
If the electrode is oily, clean it us-
ing a clean, dry rag. If the electrode
has deposits on it, polish it using