Harbor Freight Tools 2433 Pressure Washer User Manual


 
SKU 02433 PAGE 6
For technical questions, please call 1-800-444-3353;
Troubleshooting section at end of manual.
SPECIFIC SAFETY RULES
1. Maintain a safe working environment. Keep the work area well lit. Make sure
there is adequate surrounding workspace. Always keep the work area free of
obstructions, grease, oil, trash, and other debris. Do not use the Pressure Washer in
areas near flammable chemicals, dusts, and vapors.
2. Maintain labels and nameplates on the Pressure Washer. These carry important
information. If unreadable or missing, contact Harbor Freight Tools for a replacement.
3.
WARNING! Risk of injection or severe injury. Keep clear of Nozzle. Do not
direct discharge stream at people or animals. Keep the work area clear of all
people and animals.
4. Use the right product for the right job. There are certain applications for which
this product was designed. Do not use small equipment, tools, or attachments to do
the work of larger industrial equipment, tools, or attachments. Do not use this product
for a purpose for which it was not intended.
5. This product must continuously run with cold water only.
Never use hot water.
Dry running will cause serious damage to the seals. Make sure the water supply
used for the Pressure Washer is not dirty, sandy, and does not contain any corrosive
chemical products.
6. To avoid electrical shock, never start and run the Pressure Washer in the rain.
Never allow water to leak inside the Body of the Pressure Washer. Do not direct
discharge stream at the Pressure Washer itself or at other live electrical equipment.
7. Do not allow the GFCI Plug (11A) to become wet. Always place the GFCI Plug
in a dry location and as far away as possible from the object being sprayed.
Keep all electrical connections dry and off the ground.
8. When using the Pressure Washer, always maintain a firm grip on the Wash
Gun (5A) with
both hands. Squeezing the Trigger of the Wash Gun causes a kickback
force.
9. Do not pull or carry the Power Washer by its Power Cord (11A), or pull the Cord
around sharp corners or edges. Do not unplug the Power Washer by pulling on
the Cord. Keep the Cord away from heated surfaces.
10. Do not handle the GFCI Plug (11A) with wet hands.
11. Avoid unintentional starting. Make sure you are prepared to begin work before
turning on the Pressure Washer.
12. The work area should have adequate drainage to reduce the possibility of a
fall due to slippery surfaces.
13. This Pressure Washer is intended for outdoor residential use only.