Harbor Freight Tools 2433 Pressure Washer User Manual


 
SKU 02433 PAGE 10
For technical questions, please call 1-800-444-3353;
Troubleshooting section at end of manual.
ASSEMBLY
NOTE: For additional information regarding the parts discussed in the following pages,
refer to the Assembly Diagrams on pages 19-21.
1. Check the Inlet Strainer for any blockage, including packaging debris. The Pressure
Washer may be shipped with a plastic plug in the Inlet.
2. If you have not already done so, remove the foam packing block underneath the Top
Shell (4A).
3. Position the rear of the Handle (1A) above the rear of the Pressure Washer body.
Insert the Valve located at the bottom of the Handle into the Suction Tube located at
the top of the Pressure Washer body. Make sure that the Suction tube does not bend
or get pinched during assembly. Lower the Handle fully onto the Pressure Washer
Body. Then secure the Handle to the Pressure Washer body, using the four Screws
(12A) provided. (See Figure D.)
HANDLE (1A)
VALVE
SUCTION TUBE
SCREW (12A) SCREW (12A)
SCREW (12A)
SCREW (12A)
FIGURE D
REAR
VIEW