Filter
Top Products
4.See FIGURES 5&6. Loosen the LOCK Wheel (#18) to allow entire housing to turn. Rotate the housing to
match the degree of angle you need on the Angle Gauge. Chains come in various sizes with varying degrees
of sharpening angles. Check with your chain manufacturer’s manual to determine what degree you need to
sharpen at. Once the degree is set, tighten the Lock Wheel(#18).
5.Lower the Top Housing(#4) so that the Grinding Wheel(#8) skims the chain tooth.
Page 6
Operation (continued)
6.Hold it at that position while you
Tighten the Lock Stop(#6)so that the
Wheel will only go down to that point
See FIGURE7.
7.Depending on the amount of material
you wish to remove, tighten or loosen
the Lower Knob(#26) and set the Lock
Nut. Wee FIGURE5.The Lower
Konb (26) has a Lock Nut which will determine how
much materail is removed. Once you set the Lock
Nut, fully tighten the Lower Knob(26).
the Lower Knob(26).