Filter
Top Products
Operation
Warning ! Always unplug the unit while adjusting chain to be sharpened.
Refer to the assembly drawing on page 10 and the various photographs.
Note: Raise the Top Housing (#4) while adjusting the chain.
1.Clean the chain before sharpening . Wash it with o non-flammable solvent. Don’t not use Gasoline. Dry the
chain.
Page 5
Operation (continued)
2.Lift up the Chain Stop(#23) and secure the chain in the sliding Guides (#31). See FIGURE 6.
3.Lower the Chain Stop(#23) so that it is positioned on the tooth (cutter)you want to start with. See FIGURE 5.