Filter
Top Products
4 -10
4.1 CONTROLS AND FEATURES
4.2 FILLING THE FUEL TANK
Add fuel to the fuel tank as needed. See your engine
manual for the correct type and grade of fuel.
Put the unit in an open area. Stop the engine and lock
the brake. Clean the fuel cap and the area around the
fuel cap to prevent dirt from entering the fuel tank.
Remove the cap from the fuel tank. Fill the fuel tank.
Be careful not to spill the fuel. Install the cap on the fuel
tank and tighten. Clean up any spilled fuel before
starting the engine.
SECTION 4 - GENERAL MAINTENANCE & ADJUSTMENTS
1. Direction Control Lever
2. Steering Brake Handlebar (Optional)
3. Gear Shift Lever (Hi/Low Gear)
4. Operator Presence Control
5. Choke Control Knob (Models with Briggs & Stratton
Engines)
6. PTO Control
7. Ignition Switch
8. Kick Stand
9. Throttle Control
10. Hour meter
11. Brake Handle Cross Bar
12. Range Shift Handle (Two Speed Axle)
13. Parking Brake Handle (Optional on 8.5 HP)
14. Instruction Plate
15. Choke Lever (Models with Robin Engines)
16. Choke Control Knob (Models with Briggs & Stratton
Figure 1
OH0160
1
2
3
4
6
7
8
9
10
11
12
13
14
15
5
4
4
WARNING:
Use caution with fuel. Fuel is very
flammable. Keep fuel in a clean and tight
container. Keep fuel away from fire or heat.
Never put fuel in the fuel tank while the engine
is running or hot. Clean up any spilled fuel
before starting engine.