Filter
Top Products
22 Genie Z-34/22 IC Part No. 82594
Operator's Manual Third Edition • First Printing
Machines equipped with Platform Level Control
Disable Function: The platform level toggle switch
will not operate when the primary boom is raised
past the drive speed limit switch.
Operation from Platform
1 Turn the key switch to platform control.
2 Pull out both ground and platform red
Emergency Stop buttons to the on position.
3 Gasoline/LPG models: Choose fuel by moving
the fuel select switch to the desired position.
4 Start the engine. Do not press down the foot
switch when starting the engine.
To Position Platform
1 Press down the foot switch.
2 Slowly move the appropriate function control
handle or toggle switch according to the
markings on the control panel.
Machines equipped with Platform Level Control
Disable Function: The platform level toggle switch
will not operate when the primary boom is raised
past the drive speed limit switch.
To Steer
1 Press down the foot switch.
2 Turn the steer wheels with the thumb rocker
switch located on top of the drive control
handle.
Use the color-coded direction triangles on the
platform controls and the drive chassis to identify
the direction the wheels will turn.
OPERATING INSTRUCTIONS
To Drive
1 Press down the foot switch.
2 Increase speed: Slowly move the drive control
handle off center.
Decrease speed: Slowly move the drive control
handle toward center.
Stop: Return the drive control handle to center or
release the foot switch.
Use the color-coded direction arrows on the
platform controls and the drive chassis to identify
the direction the machine will travel.
Machine travel speed is restricted when the booms
are raised or extended.
Drive Enable
Light on indicates that the boom
has moved just past either non-
steer wheel and the drive
function has been interrupted.
To drive, hold the drive enable switch to either side
and slowly move the drive control handle off center.
Be aware that the machine may move in the
opposite direction that the drive and steer controls
are moved.
Always use the color-coded direction arrows on the
platform controls and the drive chassis to identify
the direction the machine will travel.
Drive Speed Select
· Machine on incline symbol: Low range operation
for inclines
· Machine on level surface symbol: High range
operation for maximum drive speed