Filter
Top Products
Part No. 43650 Genie S-80 & Genie S-85 5
Operator's ManualSecond Edition · Fifth Printing
SAFETY RULES
Collision Hazards
Be aware of limited sight
distance and blind spots
when driving or operating.
Be aware of boom position and tailswing when
rotating turntable.
Check work area for overhead obstructions or other
possible hazards.
Be aware of crushing hazard when grasping the
platform guard rail.
It is recommended that operators wear an approved
hard hat when operating the machine.
Observe and use color-coded direction arrows on
the platform controls and drive chassis for drive
and steer functions.
Do not lower the boom unless the area below is
clear of personnel and obstructions.
Limit travel speed according to condition of ground
surface, congestion, slope, location of personnel
and any other factors which may cause collision.
Do not operate a boom in the path of any crane
unless the controls of the crane have been locked
out and/or precautions have been taken to prevent
any potential collision.
No stunt driving or horseplay while operating a
machine.
Component Damage Hazards
Do not use any battery or charger greater than 12V
to jump-start the engine.
Do not use machine as a ground for welding.
Be sure hydraulic shutoff valves (located by
hydraulic tank) are open before starting engine.