Filter
Top Products
Part No. 43650 Genie S-80 & Genie S-85 27
Operator's ManualSecond Edition · Fifth Printing
Use lower platform mount between boom end and
platform to secure boom from side-to-side
movement. Do not use excessive downward
force when securing boom section.
Use chains or straps of ample load capacity.
Turn key switch to the OFF position and remove
key before transporting.
Inspect entire machine for loose or unsecured
items.
Free-wheel Configuration for
Winching
Chock wheels to prevent machine from rolling.
2WD models: Release non-steer wheel brakes by
turning over torque hub disconnect caps (see
below).
4WD models: Release wheel brakes by turning
over all four torque hub disconnect caps (see
below).
Be sure winch line is properly secured to drive
chassis tie points and path is clear of all
obstructions.
Reverse procedures described to re-engage
brakes.
Note: The pump free-wheel valve should always
remain closed.
Observe and Obey:
Transport vehicle must be parked on a level
surface.
Transport vehicle must be secured to prevent
rolling while machine is being loaded.
Be sure vehicle capacity, loading surfaces and
straps or lines are sufficient to withstand
machine weight. See Specifications section.
Securing to Truck or Trailer for
Transit
Always use the turntable rotation lock pin each
time the machine is transported.
Always chock machine wheels in preparation for
transport.
Use tie points on drive chassis for anchoring down
to transport surface.
Disengage
Position
Engage
Position
Transport Instructions