Filter
Top Products
10 Automatic Standby Generator Owner’s Manual
3.2 — Circuit Breaker
The Main Line Circuit Breaker (MLCB) and control panel are located under the side panel cover. Open the side cover door to access both the
control panel and circuit breaker.
Figure 3-3: Control Panel / Circuit Breaker Location
Set to AUTO, the
engine may
crank and
start
at any time
without warning.
Such
automatic starting
occurs
when
utility
power
source voltage drops
below a
preset
level or
during
the
normal exercise
cycle.
To
prevent possible injury
that might be
caused
by such
sudden starts, always
set to OFF and
remove
the
fuse(s), disconnect the battery negative cable and shut off utility power at the MLCB
before work
ing on or around the
generator
or
transfer
switch.
Then, place a “DO NOT
OPERA
TE”
tag
on the
generator
panel and on the
trans
fer
switch.
NOTE: The generator is to be run with all appropriate panels in place, including during troubleshooting by a technician.
3.3 — Control Panel
Figure 3-4: Generator Control Panel and LEDs
NOTE: The control panel on this unit is intended to only be operated by qualified service personnel.
Circuit Breaker (MLCB) Control Panel
*
Operation
Mode
Buttons
and LEDs
Warning
LEDs
Alarm
LEDs