Generac 1537-0 Pressure Washer User Manual


 
GeneracPortableProducts2,400PSIHighPressureWasher
NOTE: Your pressure washercomes with a quick connect
that you can useto attach the high pressure hose to either
the pump or spraygun.
Uncoil the high pressure hose and attach the female
quick connect to one end of the hose. Attach the male
quick connect to the high pressure fitting on the pump
(Figure 7).
Attach the hoseto the baseof the spray gun (Figure 8).
Tighten by hand.
Attach the other end of the high pressure hose to the
high pressure outlet on the pump (Figure 9). Pull down
on the collar of the quick connect, slide onto the pump
and let go of collar. Pull on hose to be sure of a tight
connection.
Beforeyou connect your garden hose to the water inlet,
inspect the inlet screen (Figure 10).Clean the screen if it
contains debris, replaceit if it is damaged.DO NOT RUN
THE PRESSUREWASHER IFTHE SCREENISDAMAGED.
Run water through your garden hose for 30 seconds to
cleanout any debris. Turn off water.
Connect the garden hoseto the water inlet. Tighten by
hand (Figure 10).
_ ARNING! There MUST be at least ten feet of
unrestricted garden hose between the pressure
washer inlet and any flow shut off device, such as a
'Y' shut-off connector or other convenience-type
water shut-off valve. Damage to pressure washer
resulting from disregarding this warning will not be
covered by the warranty.
Turn ON the water and squeeze the trigger on the spray
gun to purge the pump system of air and impurities.
_ CAUTION! Before starting the pressure washer,
be sure you are wearing adequateeye protection.
Checklist Before Starting Engine
Review the unit's assemblyto confirm you haveperformed
all of the following:
Make sure the handle isin placeand secure.
Check that oil hasbeen added to the proper level in the
engine crankcase.
Add the proper gasolineto fuel tank.
Check for properly tightened hose connections.
Check to make sure that there are no kinks, cuts, or
damageto the high pressure hose.
Provide a proper water supply (not to exceed 140°F)at
an adequateflow.
Be sure to read "Safety Rules" and "How To Use Your
PressureWasher" before usingthe pressure washer.
/
7