Filter
Top Products
GeneracPortableProducts2,400PSIHighPressureWasher
IMPORTANT: Readentire owner's manualbefore you
attempt to assembleor operate your new pressure washer.
REMOVE PRESSURE
WASHER FROM
CARTON
• Removethe parts box includedwith pressure washer.
• Slicetwo corners at the end of carton from top to
bottom so the panel can be folded down fiat, then
remove all packing material.
• Roll pressure washer out of carton.
Carton Contents
Items in the carton include:
Main Unit
Parts Box (which includesthe following):
Goggles
Handle Assembly
Handle FasteningHardware (which includes):
Carriage Bolts (2)
PlasticKnobs (2)
"J" Hook
Chemical Hose Clip
Nozzle Cleaning Kit
High Pressure Hose
Quick Connect
Owner's Manual
EngineManual
Owner's Registration Card
SprayGun
Nozzle Extension
Oit Bottle
O-Ring MaintenanceKit
If any of the above parts are missingor damaged,call the
pressure washer helpline at 1-800-270-1408.
PREPARING PRESSURE
WASHER FOR USE
If you haveanyproblems with the assemblyof your
pressure washer or if parts are missingor damaged,call the
pressure washer helpline at 1-800-270-1408.
To prepare your pressure washer for operation, you
will need to perform these tasks:
• Fill out and sendin the registration card.
• Attach the handle.
• Add oil to the engine crankcase.
• Add fuel to the fuel tank.
• Connect the high pressure hoseto the spray gun and the
pump.
• Connect the water supply to the pump.
Attach Handle
NOTE: All assemblyoperations given in this section will
be described from the perspective of assemblingthe
pressure washer from the rear.
• Placethe handle onto the handlesupports already
connected to the main unit. Make sure the holes in the
handle align with the holes on the handle supports
(Figure I).
Handle
Supports
NOTE: It may be necessaryto move the handle supports
from side to side in order to alignthe handle so it will slide
over the handle supports.
/
5