Generac 1537-0 Pressure Washer User Manual


 
Generac Portable Products 2,400 PSIHigh PressureWasher
Point the nozzle down towards a firm surface and press
the trigger to test the pattern (Figure 17).
Twisting the nozzle adjuststhe spray pattern from a
narrow pattern to a fan pattern (Figure 18).
Twist nozzle clockwise
counterclockwise for fan for narrow spray
For most effective cleaning, keepthe spray nozzle
between 8 to 24 inches away from cleaningsurface.
If you get the spray nozzle too close, especiallyusing high
pressure mode, you maydamagethe surface being
cleaned.
Do Not get closer than 8 inches when cleaningtires.
Applying Detergent with the
Adjustable Nozzle
A WARNING! You must attach all hoses before
you start the engine.Starting the engine without all
the hoses connected and without the water turned
ON will damagethe pump.
IMPORTANT: Use soaps designed specifically for
pressure washers. Household detergents could damage
the pump.
To apply detergent, follow these steps:
Reviewthe useof adjustable nozzles.
Prepare detergent solution asrequired by the
manufacturer.
Hangthe detergent solution on the "J" hook attached to
the accessory tray, asshown in Figure 19.
Placethe small filter end of the detergent siphoning tube
intothe detergent container.
A AUTION! Keep the detergent siphoning tube
from coming in contact with the hot muffler.
Slide the adjustable nozzle forward to low pressure
mode. Detergent cannot be applied with the nozzle in
high pressure position.
Make sure the garden hose is connected to the water
inlet.Check that the high pressure hose isconnected to
the spray gun and the pump. Start the engine.
/
10