Filter
Top Products
3
GB
User interface:
Setting up:
Warning!
The Water Timer must not be used
indoors.
v Only use the Water Timer outdoors.
The Water Timer must only be set up vertically
with the sleeve nut to the top to prevent water
penetrating into the battery compartment.
The minimum water output to ensure that
the Water Timer functions correctly is
20
-
30 l/h.
For example, at least 10 x 2-litre Drip Heads are
required to control the Micro-Drip-System.
The max. temperature for the water flow is
40°C.
v Only use clear fresh water.
The minimum operating pressure is 0.5 bar, the
maximum operating pressure is 12 bar.
Avoid tensile strain.
v Do not pull the hose connected to the
Water Timer.
Programming
v Program the Water Timer with the tap
turned off.
In this way you can avoid getting wet when
trying out the manual On /Off function (man.
On/Off). You can remove the control unit from
the housing to program the Water Timer.
If the controller is removed when the valve is
open, the valve remains open until the con-
troller is fitted again.
3. Function
With the Water Timer, the garden can be watered fully automati-
cally up to 3 times a day at any time of day (every 8 hours).
Sprinklers, a sprinkler system or a drip head watering system can
be used for watering.
The Water Timer carries out watering fully automatically according
to the set program and can therefore also be used during holidays.
Evaporation is lowest in the early morning or late evening.
The watering program is simply set via the controls.
1
Run-Time control knob (watering time)
2
Frequency control knob (watering frequency)
3
Battery level LED
When the Battery display flashes continually, the battery is
empty and the valve is no longer opened.
A valve opened by the program is also closed again with
an empty battery.
The battery display is reset when the battery is changed.
v Replace battery (see 4. Putting Your Water Timer into Operation
“Insert battery”
).
v Test battery (see 4. Putting Your Water Timer into Operation
“Test battery”
).
1
2
3