Ferris Industries 5900592 Lawn Mower User Manual


 
17
Glow Plug Indicator
Lamp that indicates that the glow plugs are heating.
Hold the ignition key in the “HEAT” position until
indicator lamp turns off, then turn the key to start.
Voltage Gauge
Gauge measures the output voltage of the engine
charging system.
Oil Pressure Indicator
Lamp that indicates a low oil pressure condition. If
the indicator lamp is ON, it will turn the PTO OFF.
Water Temperature Gauge & Indicator
Gauge measures the engine coolant temperature.
Lamp that indicates a high coolant temperature. If
the indicator lamp is ON, it will turn the PTO OFF.
Ignition Switch
The ignition switch starts and stops the engine, it has
four positions:
HEAT Heats the glow plugs.
OFF Stops the engine and shuts
off the electrical system.
RUN Allows the engine to run and
powers the electrical system.
START Cranks the engine for
starting.
NOTE: Never leave the ignition switch in the ON
position with the engine stopped–this drains the
battery.
Hydraulic Mower Lift Switch,
Cutting Height Adjustment Pin & Deck
Lift Lock Lever
Press the mower lift switch to the right (away from the
operator’s seat) to raise the mower deck it locks into
the 6” (15,2 cm) position. Place the adjustment pin
in the desired cutting height and release the lift lock
lever.
PTO (Power Take Off) Switch
The PTO switch engages and disengages the mower.
Pull UP on the switch to engage the mower, and push
DOWN to disengage the mower.
Throttle Control
Moving the throttle control fully forward is FULL
throttle position. Always operate the unit at FULL
throttle when mowing.
Hour Meter
The hour meter measures the number of hours the
PTO has been engaged. The hour meter has a self
contained power source so the total hours are always
visible.
Features & Controls
Fuel Level Gauge
Displays the fuel level in the tank.
Power Outlet
Unit is equipped with a +12VDC, 20A power outlet.
Not for
Reproduction