Exmark Metro 26 Lawn Mower User Manual


 
27
4.13 Changing the Oil Filter:
Service Interval: Replace the oil filter after every 100 operating hours.
FIGURE 24
a) Run the engine to warm the oil.
WARNING
POTENTIAL HAZARD
Oil may be hot after engine has been run.
WHAT CAN HAPPEN
Contact with hot oil can cause severe
personal injury.
HOW TO AVOID THE HAZARD
Avoid contacting the hot engine oil when
you drain it.
a) Stop the engine and wait for all moving parts to stop.
b) Disconnect the wire from the spark plug (Figure 3).
c) Drain the engine oil.
d) Place a rag under the oil filter to catch any oil that may leak out as you remove
the filter.
e) Remove the oil filter.
f) Use your finger to coat the gasket on the new filter with clean engine oil.
FIGURE 25
g) Install the new filter and hand tighten it 2/3 turn only.
h) Fill the crankcase to the Full line on the dipstick with fresh oil.
i) Connect the wire to the spark plug.
j) Run the engine for about 3 minutes.
Gasket
G0228