Filter
Top Products
20
c) Hold the running garden hose a handle level and direct the water to flow on the
ground just in front of the right rear tire (Figure 11).
FIGURE 11
d) Engage the blade.
NOTE: The blade will draw in water and wash out clippings. Let the water run until
you no longer see clipping being washed out from under the housing.
e) Disengage the blade, stop the engine and wait for all moving parts to stop.
f) Turn off the water.
g) Start the lawn mower, engage the blade, and let the lawn mower run for a few
minutes to dry out its components.
Scraping Method
If washing does not remove all debris from under the lawn mower, scrape it clean.
a) Disconnect the wire from the spark plug.
b) Drain the fuel from the fuel tank. Refer to section 4.8, Emptying the Fuel Tank
and Cleaning the Fuel Filter.
WARNING
POTENTIAL HAZARD
♦ Tipping the lawn mower may cause the
fuel to leak from the carburetor or the fuel
tank.
WHAT CAN HAPPEN
♦ Gasoline is extremely flammable, highly
explosive, and under certain conditions,
can cause personal injury or property
damage.
HOW TO AVOID THE HAZARD
♦ Avoid fuel spills by running the engine dry
or by removing the gasoline with a hand
pump; never siphon.
c) Tip the lawn mower onto its right side.
d) Remove the dirt and grass clippings with a hardwood scraper. Avoid burrs and
sharp edges.
e) Turn the lawn mower upright.
f) Fill the fuel tank.
g) Connect the wire to the spark plug.
4.4 Cleaning the Discharge Tunnel
:
Service Interval: After each use.
Always be sure that the discharge tunnel door closes securely when you remove the
bag. If the debris prevents the discharge door form closing securely, clean the inside of
the discharge tunnel and the door thoroughly.
G0213