Filter
Top Products
11
POWER BLOWER
OPERATOR’S MANUAL
ASSEMBLY
WARNING DANGER
Never perform maintenance or assembly procedures with engine
running or serious personal injury may result.
INSTALL BLOWER PIPES
1. Assemble throttle lever bracket to the fancase using four screws.
- Set stop lead into the recess of bracket.
2. Assemble the flexible pipe thru elbow to the blower and tighten
clamp.
3. Assemble the flexible pipe and the straight pipe w/swivel and
tighten the clamp.
4. Assemble straight section of the pipe to the other end of the pipe.
5. Assemble the curved pipe and rotate the desired angle.
6. Shoulder harness is adjustable to fit any operator.
7. Adjust the length of strap for easier operation.
INSTALL STICK HANDLE
1. Remove blower pipe from swivel tube.
2. Loosen wing nut completely and expand open stick handle.
3. Align notches in handle clamp with pipe pegs. Handle should be
angled away from operator.
4. Slide handle onto swivel tube.
5. Position handle for comfortable operation and tighten wing nut.
6. Install blower pipe to swivel tube.
Swivel
tube
Wing nut
Stick handle
Notch
Pipe pegs
Stick handle
Flexible pipe
Clamp
Screws
Stop lead
Elbow
Pipe