Filter
Top Products
10
3. To raise or aerate the soil, tilt engine closer to the ground which
will raise cultivator tines higher relative to the soil surface.
IMPORTANT
Do not operate cultivator underwater. The gear housing is not
sealed and water will wash away lubrication, damaging gears,
bearings, and seals.
A
RESETTING TINES FOR DEEP CULTIVATION
Tools Required: 10 mm Wrench
The tines are factory assembled with blade ends offset for standard
cultivation. For deep cultivation, the left tine (viewed from the operator's
position) must be repositioned on the hub aligning the left and right tine
blade ends directly across from each other.
1. Remove three (3) bolts (A) mounting left tine to hub. The bolts will
be mounted in hole labeled (1).
2. The cultivator attachment is capable of tilling in the forward or
reverse direction. For deep soil tilling, till forward then lightly pull
unit rearward allowing the tines to make a deeper cut into the soil.
Deep soil cultivating can also be enhanced by repositioning the
tines. (Refer to Tine Setting).