Filter
Top Products
Escape 1400 Insert Installation and Operation Manual
50
Align the notch in the
faceplate extension with the
bolt (O) welded to the air
jacket located and slide the
faceplate assembly just over
the washer (P) and bolt’s head
(Q). Then push towards the
fireplace.
If necessary, adjust the height
of the insert using the leveling
bolts on each side of the
convection air jacket until the
faceplate is properly seated on
the floor of the hearth
extension.
Once the faceplate is in place,
secure the assembly by
tightening nut (Q) using a
7/16" (11 mm) open end
wrench.