Filter
Top Products
Escape 1400 Insert Installation and Operation Manual
47
Appendix 3: Optional Faceplate and Decorative Trims
Installation (AC03350 / AC03360)
Note: The illustrations may vary from one model to another, but the method of assembly
remains the same.
Remove the faceplate panels from its box and the faceplate extension secured between
the firebox and the convection air jacket.
Place the faceplate panels with the finished side down on a flat, soft, non-abrasive surface
and follow the installation instructions below;
Hardware bag content:
8 - #10-24" x 1/2" bolts 2 - Corner bracket and screws
8 - Trim retainer 8 - #10-24" hex nuts
Line up the holes of the upper faceplate
panel (A) with the holes of the side
panels (B) and (C). Secure them
together using four (4) bolts (D) and nuts
(E) provided.
Partially thread the screws (F) on the
trim's corner bracket (G) then
superimpose the corner brackets (G)
and (H) as shown in the image on the
left.