Filter
Top Products
Escape 1400 Insert Installation and Operation Manual
45
Appendix 1: Blower Installation
First, attach the blower assembly (A) to
the insert by aligning and inserting the
hooks on each side of the blower
housing into the slots located on the left
and right of the blower opening below
the loading door.
To assemble the ash lip (B), open the
door to facilitate the installation. Center
the ash lip with the blower assembly
previously installed and push it against
the firebox. Then push down the rear
fold of the ash lip so it clips into the two
(2) brackets welded to the firebox
located below the loading.