Dolmar MS-245.4 U Brush Cutter User Manual


 
31
(e) MAINTENANCE STATEMENTS
It is your responsibility to have all scheduled inspection and maintenance services performed at the times
recommended in the 2007 and later Owner’s Manual and to retain proof that inspection and maintenance
services are performed at the times when recommended. Dolmar will not deny a warranty claim solely because
you have no record of maintenance; however, Dolmar may deny a warranty claim if your failure to perform
required maintenance resulted in the failure of warranted part. The proof, which you maintain, should be given
to each subsequent owner of the engine. You are responsible for performing the scheduled maintenance
described below based on the procedures specied in the 2007 and later Owner’s Manual. The scheduled
maintenance below is based on the normal engine-operating schedule.
PROCEDURE INTERVAL
1) Clean engine and check bolts and nuts. Retighten if
necessary.
: Every 8 hours (daily)
2) Check and rell engine oil (4 stroke engine only) : Every 8 hours (rell daily up to upper limit)
3) Change engine oil (4 stroke engine only) : Initial 20 hours and every 50 hours afterward
4) Check clogging of cooling air passage and cylinder
ns. Remove and clean if necessary.
: Every 8 hours (daily)
5) Clean air cleaner. : Every 8 hours (daily)
6) Check spark plug. Clean and adjust if necessary. : Every 8 hours (daily)
7) Check mufer exhaust outlet (or port). Clean if
necessary.
: Every 50 hours (monthly)
8) Check fuel lter. If clogged, replace with new one. : Every 50 hours (monthly)
9) Adjust valve clearance, if applicable (4 stroke
engine only).
: Every 200 hours (yearly)
10) Replace fuel lines. : Every 200 hours (yearly)
11) Clean and inspect the complete engine. Replace
any damaged or worn out parts.
: Every 200 hours
12) Replace packings and gaskets with new ones. : Every reassembling