Filter
Top Products
13
Inspection and rell of engine oil
– Perform the following procedure, with the engine cooled down.
– While keeping the engine level, remove the oil gauge, and conrm that the oil is lled within the upper and lower limit marks.
When the oil is in short in such a way that the oil gauge touches the oil only by its tip, in particular with the oil gauge remaining inserted in the
crankcase without screwing-in (Fig. 1), rell new oil near the port (Fig. 2).
– For reference, the oil rell time is about 10h (10 times or 10 tanks of oil rell).
If the oil changes in color or mixes with dirt, replace it with new one. (For the interval and method of replacement, refer to P 19)
Recommended oil: SAE 10W-30 oil of API Classication, Class SF or higher (4-stroke engine for automobile)
Oil volume: Approx. 0.08L
Note: If the engine is not kept upright, oil may go into around the engine, and may be relled excessively.
If the oil is lled above the limit, the oil may be contaminated or may catch re with white smoke.
Point 1 in Replacement of oil: “Oil gauge”
– Remove dust or dirt near the oil rell port, and detach the oil gauge.
– Keep the detached oil gauge free of sand or dust. Otherwise, any sand or dust adhering to the oil gauge may cause irregular oil
circulation or wear on the engine parts, which will result in troubles.
– As an example to keep the oil gauge clean, it is recommended to insert the oil gauge on its knob side into the engine cover, as shown
in Fig. 3.
Oil gauge
If oil adheres around
this tip, rell new oil.
Fig. 1
Upper limit
(Edge of oil rell port)
Fig. 2
Fig. 3
BEFORE START OF OPERATION
(1) Keep the engine level, and detach the oil gauge.
(2) Fill oil up to the edge of the oil rell port. (Refer to Fig. 2 of the preceding
page).
Feed oil with the lubricant rell container.
(3) Securely tighten the oil gauge. Insufcient tightening may cause oil leakage.