Filter
Top Products
27
OPERATION INSTRUCTIONS
TESTING OF SAFETY INTERLOCK SYSTEMS
The following tests should be performed at the start of each
mowing day.
BLADE DRIVE SWITCH TEST
1. Put park brake in ON position.
2. Swing control levers to outward position.
3. Engage blade drive switch.
4. Turn ignition switch to START.
ENGINE SHOULD NOT TURN OVER OR
ATTEMPT TO START.
SEAT SWITCH TEST
1. In a safe area away from bystanders, start engine.
2. Leave control levers in outward position and put park
brake in OFF position.
3. Rise slightly off seat. Engine should stop!
4. Restart engine.
5. Leave control levers in outward position and put park
brake in ON position.
6. Make sure area is clear of bystanders. Engage blade
drive and rise slightly off the seat. Engine should stop!
NOTE: If any safety check fails, do not operate the mower until
the system has been checked and repaired by an
authorized Dixon dealer.
WARNING
!
Failure to observe the following instructions
could result in serious injury or death.