Filter
Top Products
CARE AND MAINTENANCE
42
NEUTRAL ADJUSTMENT
1. Lift seat.
2. Block up the unit so that the drive wheels are off the
ground. Remove rear tires.
3. Loosen jam nuts on both ends of the control rod coupler.
NOTE: The rear jam nuts are left hand threads.
4. With steering control arms in the outward (neutral)
position, start the engine and run at fast idle.
5. Adjust the neutral position by turning the control rod
coupler until the hubs do not rotate.
6. Retighten the jam nuts against the control rod coupler and
check to see that the drive wheels are not turning.
7. Repeat steps 3-6 for the other side.
8. Shut off engine before reinstalling rear tires and removing
the blocks.