Filter
Top Products
CONTROLS
20
—Fig. 3—
PARK BRAKE
The park brake is designed to hold the mower
from moving and is not intended for use in
stopping the mower while it is in motion. The
engine will stop if the park brake is engaged while
the control levers are in the drive position.
TO SET PARK BRAKE
The hand-operated park brake is located on the
operator’s left.
•To engage brake, pull lever up (to the rear).
•To release brake, move lever forward (down).
NOTE: Always set park brake before dismounting.
Release park brake before moving mower.
The pressure required to operate the mower is very light.
CAUTION
!
Engage park brake before
starting engine.