13Page
SPECIFICATIONS
Model ZTR 5017Twin
CHASSIS: 11 GA - rectangular tube
BODY: Two piece - made of rotational molded polyethylene. Front body contains access panels for
battery service and engine to mower deck belt removal. Rear body tilts up to allow service on
the entire drive system.
SEAT: Designed for operator comfort by use of high density closed cell foam padded back rest and
arm rests, upholstered with Cordura
TM
water-repellent fabric. Seat is adjustable fore and aft.
MOWER DECK: 2 Decks are available. 42" is constructed of 13 ga stamped steel. 50" is a fabricated deck. 3
blades combine for either a 42" or 50" cut width. cut width. Cut height approximately 1.5"
to 4.5" via 7 position lift handle.
BLADE DRIVE: Electric clutch
DRIVE SYSTEM: Each rear wheel is independently driven by a HydroGear BDU-10L Series 70 hydrostatic
transmission. The hydrostatic transmissions, in turn, power a fully enclosed HydroGear
gearbox.
ENGINE: 17HP Briggs & Stratton V-Twin, overhead valves, replaceable oil filter, full pressure lube
system, dual element air cleaner, integral fuel pump.
STARTING SYSTEM: Electric by key switch operation with safety interlocks on parking brake and blade drive
clutch.
TIRES: Front 11 X 4 X 5 Ribbed Tread
Rear 18 X 9.5 X 8 Multi Trac
RECOMMENDED Front 16 - 21 lbs.
TIRE PRESSURE: Rear 8 - 14 lbs.
CAPACITIES: Fuel - 4.8 gallons total (dual tanks)
Hydrostat oil tank - 3 quart with in-line 40 micron filter
Hydrostat oil recommendation, refer to page 39
Engine - 2 qts. SAE 30 (with filter)
DIMENSIONS: Width 54" (42" Deck), 60" (50" Deck)
Height 45"
Length 72"
Weight 615 lbs (42" Deck), 668 (50" Deck)
NOTE: Additional information provided in service instructions under the individual component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE