Dixon 5000 Series Lawn Mower User Manual


 
Page 12
CHASSIS: 11 GA - rectangular tube
BODY: Two piece - made of high-density polyethylene. Front body contains access panels for
battery service and engine to mower deck belt removal. Rear body tilts up to allow service on
the entire drive system.
SEAT: Designed for operator comfort by use of high density closed cell foam padded back and arm
rests, upholstered with Cordura
TM
water-repellent fabric. Seat is adjustable fore and aft.
MOWER DECK: 2 Decks are available. 60" is made of stamped steel. 50" is made of 11 GA fabricated welded
construction with external reinforcement ribs. 3 blades combine for either a 50" or 60" cut
width. Cut height approximately 1.5" to 4.5" via 7 position lift handle.
BLADE DRIVE: Electric clutch
DRIVE SYSTEM: Each rear wheel is independently driven by a HydroGear BDU-10L Series 70 hydrostatic
transmission. The hydrostatic transmissions, in turn, power a fully enclosed HydroGear
gearbox.
ENGINE: 23HP Kohler Command, 4-Cycle, V-Configuration, Overhead Valve, Air-Cooled, Gasoline,
Vertical Shaft, Aluminum Head, and Crankcase with Cast Iron Liners, Full Pressure
Lubrication/Full Flow Filter, Pulse-type Fuel Pump, Fixed Jet Carburetor w/Smart-Choke,
Electronic Ignition, In-Line Fuel Filter, Dual Element Air Cleaner.
STARTING SYSTEM: Electric by key switch operation with safety interlocks on parking brake and blade drive
clutch.
TIRES: Front 11 X 4 X 5 Ribbed Tread
Rear 20 X 10 X 8 Multi Trac
RECOMMENDED Front 16 - 21 lbs.
TIRE PRESSURE: Rear 8 - 14 lbs.
CAPACITIES: Fuel - 4.8 gallons total (dual tanks)
Hydrostat oil tank - 3 quart with in-line 40 micron filter
Hydrostat oil recommendation, refer to page 39
Engine - 2 qts. SAE 10W30 (with filter)
DIMENSIONS: Width 60"(50" Deck), 72"(60" Deck)
Height 45"
Length 72"
Weight 680 lbs.(50" Deck), 685 lbs.(60" Deck)
NOTE:
Additional information provided in service instructions under the individual component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
Model ZTR 5023
SPECIFICATIONS