Filter
Top Products
Dimension One Spas – @Home Series Owner’s Manual
5
Initial Startup
IMPORTANT: About your GFCI Circuit Breaker — The GFCI (Ground Fault Circuit Interrupter — also called a
"circuit breaker") is an electrical safety switch that automatically shuts off power to the spa in case of an electrical
malfunction. You must have a GFCI installed according to your local building codes in an electrical power box near
your spa. The GFCI should be OFF before you fill your spa. You can manually turn off power to the spa any time by
using the GFCI. Just push the switch to the OFF position. After turning off the GFCI, make sure the control panel
display window is blank, so you know the power is off. When you are ready to turn the power back on, you can reset the
GFCI by returning the switch to the ON position.
If you have questions about the location or operation of your GFCI, ask your dealer to explain it to you. Do not use your
spa unless you understand the operation of the GFCI.
1. Locate the Topside Control Panel. The equipment
compartment is located on the side of the spa
below this panel.
2. Use a Phillips screwdriver to remove the
equipment compartment screws.
3. Locate the hose bib (pictured at right) included in the owner’s manual packet. The packet
is shipped inside the equipment compartment. This bib allows you to later connect a hose
to your spa to drain it.
4. Screw the hose bib onto the male drain fitting located at the bottom
of the hot tub, on the pedestal, to the lower right side of the
equipment compartment (see arrow in the photo at right).
5. Close the valve on the side of the hose bib (if it is not already
closed) by turning the valve handle perpendicular to the pipe.
6. Check the pump unions (see arrows in illustration) to be sure they are hand tight to prevent the possibility of
leakage
.