Filter
Top Products
Dimension One Spas – @Home Series Owner’s Manual
9
Control Function
4
4. HEAT Indicator Light
This light glows when the heater is on.
5
5. JETS 1 Button
On American models, pushing the JETS 1 Button once starts the pump on LOW
speed. Pushing it a second time turns on HIGH speed. Pushing it a third time
turns the pump off. (European models have only one jet speed: High).
NOTE: A built-in timer will automatically shut the pump off after 30 minutes
(60 minutes on some models), unless you turn it off manually.
A new 30-minute cycle begins for each pump when its JETS button is pushed.
You can use this function to cause the spa to filter immediately after use—just
push the Jets button once when you get out.
The indicator light will glow when the jet pump is running.
6
6. JETS 2 Button
If your spa is equipped with a second jet pump then you will have a JETS 2
button. Pushing the button once starts the secondary (single speed) pump.
Pushing it again stops the secondary pump.
The Jets 2 indicator light will glow when the secondary jet pump is running.
7
7. LIGHT Button and Status Light
Push the LIGHT button once to turn the light on. Push it again to turn it off.
The light will automatically turn off after 1 hour of continuous operation.
NOTE: If your spa has the optional Dynamic L.E.D. Light installed, then the
Light button allows you to change its color sequences. See the section on the
Dynamic L.E.D. light later in this manual.