Filter
Top Products
2002 @ Home Hot Tubs
Owner’s Manual
Control Function
4
4.HEAT Indicator Light
This Light is illuminated the heater is on.
5
5. JETS 1 Pad and Status Light
When the JETS 1 control pad is pushed the first time, the primary pump will
turn on in low speed. When the JETS 1 pad is pressed a second time, the
primary pump will switch to high speed. Push the JETS 1 pad a third time and
the primary pump will be turned off.
NOTE: The Dream HP, Sojourn HP and Cove HP are dual pump spas. The
upper control panel will have two jet pads (JETS 1 and JETS 2). The primary
pump (JETS 1) is a two-speed pump with a High and Low speed setting. The
secondary pump (JETS 2) is a single speed pump with only one speed setting. All
other @Home Hot Tubs have one two speed jet pump and therefore have only
one jet pad. If the spa is heating, pump one will run continuously at low speed
until the pre-set temperature is reached. The set point light indicator will be on
when the display is showing the water temperature set point. It will be off when
the display is showing the actual water temperature.
NOTE: When a bather turns on a pump by pressing either JETS 1 or JETS 2, it
will run for 30 minutes and then turn off. A new 30 minute cycle begins for
each pump when its respective JETS pad is pushed. This auto shut-off cycle is a
safety feature and also allows for convenient filtration, immediately after use of
the spa.
6
6. JETS 2 Pad
If your hot tub is equipped with a secondary pump (Dream HP, Sojourn HP and
Cove HP) then you will have a JETS 2 pad. The first time the JETS 2 pad is
pushed it will start the secondary (single speed pump) and when pushed a
second time it will stop the secondary pump.
7
7. LIGHT Pad and Status Light Push the LIGHT control pad once to turn
the light on. Push the LIGHT control pad a second time to turn off the light.
The light LED is on or off according to the light’ current state. The light will
automatically turn off after 1 hour of continuous operation.
NOTE: If the Dynamic L.E.D. is installed, the low, medium, and high settings
are disabled. The Light pad turns the Dynamic L.E.D. on and off.
10