Filter
Top Products
Sonic Immersion System Dealer Installation Guide
2. Using measurement obtained for Horizontal Position (HP),
measure from side of panel, see below, and mark spot with a
fine point marker.
3. The point where these two lines intersect is the upper right
corner of the template (P/N Doc 74 Rev A).
4. Align the upper right corner of the template with the mark
on the panel. Use a center punch to mark the spot.
5. Square up the template on the panel and use the center
punch to mark the other three corners.
6. Using a machinist’s square or straight edge, connect all four
marks.
33