Filter
Top Products
Sonic Immersion System Dealer Installation Guide
8. Locate the wire coming from the sub-woofer. This wire is
covered with clear insulator. The wire has two conductors.
One is copper-colored and the other is silver. Strip
approximately ½ inch of insulator from each wire and twist
each to form a tight bundle. Connect the copper colored
wire to the terminal marked” CH2 (REAR) + LEFT”. Connect
the silver colored wire to the terminal marked” CH2 (REAR)
– RIGHT”.
9. Connect red and white preamp input wires to the Line Level
Input terminals as follows: connect Channel 1 (flat speaker)
to red and white terminals on left, connect Channel 2 (sub-
woofer speaker) to red and white terminals on right.
23